NEC ExpEther-2S, User Manual

Page: 64 / 112

44
Tip
To change the group ID of the IO expansion unit to another group ID, initialize
the group ID and update it.
You can initialize the group ID by executing the subcommand “del_gid”.
If there is no ExpEther board that has the specified group ID to be set for the IO
expansion unit, the command generates an error.
Important If you instruct the ExpEther board to change the Group ID, the board will reset
itself because it reflects the new ID. This may affect operation of the OS. Thus,
when performing this, pay attention to the OS operating state.
After changing the Group ID, need to restart the server.
Important If you instruct the ExpEther I/O Expansion Unit to change the Group ID, the I/O
device will be disconnected from the currently connected ExpEther board. This
may affect operation of the OS. Thus, when performing this, pay attention to the
OS operating state.
del_gid
Delete the group ID set for the ExpEther unit.
eemcli.py del_gid --id ID [--time TIME]

--id ID, -i ID: Specify the EE card ID.

--time TIME, -t TIME: Specify the update time of the device information (elapsed time from
1970/1/1 00:00:00 000 UTC in milliseconds).
o
Specify
“--time/--t” to verify whether the specified update time is equal to that of the
device information.
Tip
The group ID of the ExpEther board is initialized to 4094 and that of the IO
expansion unit is initialized to 4093 by executing this command.
Important If you instruct the ExpEther board to change the Group ID, the board will reset
itself because it reflects the new ID. This may affect operation of the OS. Thus,
when performing this, pay attention to the OS operating state.
After changing the Group ID, need to restart the server.
Important If you instruct the ExpEther I/O Expansion Unit to change the Group ID, the I/O
device will be disconnected from the currently connected ExpEther board. This
may affect operation of the OS. Thus, when performing this, pay attention to the
OS operating state.
set_vlantagging
Update the VLAN tag conversion mode of the ExpEther unit (1G and 40G).
eemcli.py set_vlantagging --id ID --state STATE [--time TIME]

--id ID, -i ID: Specify the EE card ID.

--state STATE, -s STATE: Specify
“enabled” or “disabled”.

--time TIME, -t TIME: Specify the update time of the device information (elapsed time from
1970/1/1 00:00:00 000 UTC in milliseconds).
o
Specify
“--time/--t” to verify whether the specified update time is equal to that of the
device information.
Important The setting is reflected after the server restarts. Whenever you change the
setting, restart the server.
set_multimac
Update multiple MAC address modes of the ExpEther unit (40G).
eemcli.py set_multimac --id ID --state STATE [--time TIME]

--id ID, -i ID: Specify the EE card ID.

--state STATE, -s STATE: Specify
“enabled” or “disabled”.