NEC ES1400, User Manual, Page: 99 / 188

Upgrading Your System 4-33
Installing a 5.25-Inch Device
!
CAUTION
CD-ROM devices contain a laser system and are classified as
CLASS 1 LASER PRODUCTS. To use these devices,
thoroughly read the documentation provided by the CD-ROM
manufacturer, and keep the documentation for future
reference. In case of any trouble with a CD-ROM, please
contact your nearest service representative. To prevent direct
exposure to the laser beam, do not try to open the enclosure.
Use of controls or adjustments or performance of procedures
other than those specified in the CD-ROM manufacturer's
documentation may result in hazardous radiation exposure
1.
Power off the system and remove the side panels as described earlier
in this chapter.
2.
Remove the front panel, EMI shield, and filler panel covering the bay
into which you are installing a peripheral device as described earlier
in this chapter.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
3. Remove the device from its protective wrapper and place it on an
antistatic surface. Record the drive model and serial number in the
equipment log.
4.
Set any drive jumpers or switches before you install the drive. See
the documentation that comes with the device for jumper or switch
information.
Note:
If the drive comes with drive rails, do not use them.
Remove any rails already attached.
5. Slide the drive into the bay until the screw holes line up. It may be
necessary to temporarily loosen the mounting screws on the already
installed drives to position the new drive. Secure the drive to the bay
with the four supplied screws.