NEC ES1400, User Manual, Page: 93 / 188

Upgrading Your System 4-27
8.
Slide the drive into the bay until the screw holes line up. It may be
necessary to temporarily loosen the mounting screws on the already
installed drives to position the new drive. Secure the drive to the bay
with the four supplied screws.
9.
Replace the 3.5-inch drive bay. Insert the tabs into their slots on the
chassis. Slide the drive bay towards the bottom of the chassis until
the tabs hit their stops.
10.
Connect the signal and power cables to the drives. All device power
cables are labeled and must be installed in specific locations as
shown below:
Drive Location Power Connector
1 (HD0) P7
2 (HD1) P8
3 (HD2) P9
4 (HD2) Any available power connector
11.
Swing the drive bay into the chassis and replace the three screws on
the drive bay.
12. Replace the left side panel and power on the system. Configure the
system as described in Chapter 3, “Configuring Your System.”
1
2
4
3
Cabling the Disk Drives