Before connecting an external device to the digital interface, make sure that the unit supports this
device. After the connection is completed, select the desired type of the connected device from the dropdown
list and set its parameters. If the device or its type is not listed, you can select the generic handler " MODBUS
Devices».
For users’ convenience, the device has a transparent operation mode with the connected periphery.
To avoid separate connection of the sensor to the computer, you can choose the port the sensor is connected to
in the section SETUP OF CONNECTION TO THE DEVICE, and click the "Apply" button. Then you can change the
settings of the sensor using the regular software via a virtual COM port created by the device. Before starting
operation via this port, you need to close the "Configurator" program before opening this port using a third
party software.
This mode allows you to use both built-in receivers and transmitters of the device. In this case, instead
of an external port, you need to select the built-in type of peripherals in the same drop-down list.
The devices MODBUS and CAN BUS save data in the registers and can operate in the MASTER and
SLAVE modes.
