Service Manual Chapter6. Control Electronics
© 2013
Nautilus Hyosung Inc.
All Rights Reserved.
6-15
Installing Memory Module
►
This motherboard accommodates two memory modules. It can support two 240-pin
DDR3 1333/1066.
DDR3 SDRAM memory module table
Memory module
Memory Bus
DDR3
1066
533 MHz
DDR3
1333
667 MHz
You must install at least one module in any of the two slots. Total memory capacity is
16 GB.
<Note!>
Do not remove any memory module from its antistatic packaging until you are ready
to install it on the motherboard. Handle the modules only by their edges. Do not
touch the components or metal parts. Always wear a grounding strap when you
handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1. This motherboard supports unbuffered DDR3 SDRAM .
2. Push the latches on each side of the DIMM slot down.
3. Align the memory module with the slot. The DIMM slots are keyed with notches and
the DIMMs are keyed with cutouts so that they can only be installed correctly.
4. Check that the cutouts on the DIMM module edge connector match the notches in
the DIMM slot.
5. Install the DIMM module into the slot and press it firmly down until it seats correctly.
The slot latches are levered upwards and latch on to the edges of the DIMM.
6. Install any remaining DIMM modules.
