© National Instruments
|
1-27
NI cDAQ-9132/9133/9134/9135/9136/9137 User Manual
Figure 1-19.
Installing the DIN Rail Clip on the cDAQ Controller
(cDAQ-9132/9134/9136 Shown)
2.
Insert one edge of the DIN rail into the deeper opening of the DIN rail clip, as shown in
Figure 1-20, and press down firmly on the controller to compress the spring until the clip
locks in place on the DIN rail.
Figure 1-20.
DIN Rail Clip Parts Locator Diagram
Caution
Remove the modules before removing the controller from the DIN rail.
Mounting the cDAQ Controller on a Rack
NI offers two rack mount kits, part numbers 779102-01 and 781989-01, that you can use to
mount the cDAQ controller and other DIN rail–mountable equipment on a standard 19-inch
rack. You must order the NI DIN rail mount kit in addition to these kits. Refer to the
section for the accessory part number for your cDAQ controller.
1
DIN Rail Clip
2
DIN Rail Spring
3
DIN Rail
1
2
3
