13
Network Settings
The network settings mainly set Gateway communication ports, IP configurations, and Phone Books
Manager IP etc.
Ÿ
Gateway Name: The alias registered with the Phone Books Manager.
Ÿ
Listen Port (UDP): It is not necessary to change the protocol of the communication port used by
VoIP Gateway.
Ÿ
RTP Port Base (UDP): The initial value of port number for transmitting voice data among
Gateway(s). Each line requires 2 ports. It is not necessary to change these.
For example, If the starting port is 9000, then Line 1 is using 9000 and 9001, and Line 2 is using 9002 and
9003, and so forth.
IP Configuration (Setting WAN Port)
Three methods of obtaining a WAN port IP address are given below:
1. Static IP 2. DHCP, means a Dynamic IP (Cable Modem) 3. PPPoE (Dialup ADSL). Basically, the last
two network connection methods for obtaining an IP address may vary. If not familiar with the network
connection, please contact your local ISP.
Setting Dynamic IP (DHCP)
Click “Uses DHCP” to obtain a Dynamic IP address, and then click the “Accept” button at the bottom of
the screen.
Save settings: Click
System Operation
to select “Save Settings”,
”Restart”, and then click the ”Accept” button. Wait for a while (about 30 seconds), and the system will
obtain the related IP value from the DHCP Server.
NOTE: After the system has obtained a new IP address, if using WAN Port to enter the Web
Configuration Screen, a new IP address has to be used. The same applies to the following two
settings.
Setting Static IP
Click ”Uses Static IP” and enter the IP address, Subnet Mask and Default Gateway values. Then click
“Accept” button at the bottom of the screen.
Save the settings, and then restart the system. Wait for about 40 seconds for the system to restart.
Summary of Contents for voicecom
Page 2: ......
