23
NARVON
Caution! Any operation on the lid must be
carried out manually. Do not use any tool, as
they might damage the lid or its components.
The lid top “V” is assembled to the clear
bottom “X” by applying pressure with your
hand. To disassemble it, hold the top “V” with
one hand, while you pull the bottom “X” with
the other hand.
7.8.1. Bulb replacement
The bulb must be replaced only when the
main switch is in position -0- and power cord
is unplugged.
Lift off cover “S” as showed in Figure 46 and 47. Remove
bulb “U” from bulb holder “T” and replace it with the new
one. Replace cover “S” on lid top “V”, making sure it closes
properly.
7.9. Cleaning the condenser
The condenser may be cleaned solely by a
specialized technician, who must organize
all of the operational sequences and use
suitable equipment, in strict compliance with
the applicable regulations currently in force.
Periodically clean the condenser situated inside the
machine.
Warning: Removing safety guards will expose
some sharp surfaces of the machine.
Warning: A dirty condenser will impair
machine performance.
To access the condenser, remove the safety guards.
It is forbidden to use the machine when even
only one panel (front, rear or side) is not
set properly in place. It is prohibited for the
operator to clean the condenser.
7.9.1. Cleaning the Slushy Machine
1/1FF condenser
The safety guards must be removed by means of a suitable
screwdriver.
Remove the rear guard after taking out the screws securing
it to the frame (the screws are positioned on the left and
right sides).
After removing the guard, use a dry brush to remove the
dust that has built up over time with use.
Once the condenser has been thoroughly cleaned, fit all the
safety guards back in position.
7.9.2. Cleaning Slushy Machine
2/2 FF - 3/3 FF cond.
The safety guard may be secured in place using mechanical
clips. The guard is fastened by means of clips; remove it
manually without the aid of any tool.
Fig.47
Fig.48
Fig.49
Fig.50
