Page 14
VALVE
DIAPHRAGM
EXHAUST
VALVE
BODIES
M5 SOCKET HEAD
SCREWS
Figure 4.
4. Remove the 16x M5 socket head screws and the 16x spring washers and discard them. Remove and
discard the valve bodies from the bottom manifold. (See figure 4)
5. Remove and discard the 4x diaphragms from the bottom manifold. (See figure 4)
6. Replace the 4x diaphragms and 4x valves from the service kit and replace the 16x M5 socket head screws and spring
washers from the service kit and tighten to a torque setting of 6Nm. (See figure 4)
7. Reattach the 4x solenoid coils and 4x solenoid plugs. (See figure 1)
When service B is complete reset the dryer.
Refer to:
BOTTOM
MANIFOLD
NOTE:
correct valve screw
tightening sequence shown.
3
2
4
1
CH. 13. RESETTING DRYER CONTROLLER
