NAiS GT01, Technical Manual

Page: 68 / 108

GT series
GT01 Configuration Settings
48
5.2 Entering Configuration Settings from GTWIN Screen Creation Tool
5.2.5 GT Configuration Settings: “Startup Screen Settings”
Clicking on “Start-up Screen” in the “GT Configuration” dialog box displays the screen
shown below. Here, the screen displayed when the GT01 is booted can be specified.
“Start-up Screen” screen
This is used to specify the screen that will be displayed when the GT01 is booted, as
well as the time it will be displayed. Clicking on the button for each of the items
displays a “Value Set” dialog box where the values can be specified.
Start-up Screen No. - - - This specifies the number of the screen that will be displayed
when the GT01 is booted. Clicking on the button displays a “Value Set” dialog box
where the value for the start-up screen number can be specified.
Display Time - - - This specifies the time for which the startup screen specified above
will be displayed. The value can be set to any number between 0 and 255 seconds.
Clicking on the button displays a “Value Set” dialog box where the start-up delay
time can be specified.
Key points
•
When the above settings are entered, the screen specified with the
“Startup Screen No.” parameter is displayed for the amount of time
specified with the “Display Time” parameter.
•
When the amount of time specified with the “Display Time” parameter
elapses, the screen corresponding to the number stored in the initial
address of the word device under “Basic Communication Area to
PLC” in the “Basic Setup” parameters under “GT Configuration” will
be displayed.
•
This function is used when it is necessary to delay the start-up time
when the power supply on the PLC side is turned on.