MyBinding Standard APC45 Programmable, Instruction Manual

Page: 48 / 54

40
5-2 Problems and Remedies
5-2-1 Stain, Diagonal Line, Pressing Mark and Uncut of the Sheets
Problem Causes and Remedies See
Sheets are
cut diago-
nally.
• The sheets may not hit the back-
gauge. (Make sure that the
sheets hit the backgauge.)
• There may be air between the
sheets. (Press the sheets to
remove air before cutting opera-
tion.)
• The knife may be dull. (The
replacement of the knife is nec-
essary.)
For the
Knife
Replace-
ment,
Service
Call
Diagonal
line
appears on
the cut sur-
face.
• The knife is worn or damaged.
(The replacement of the knife is
necessary.)
For the
Knife
Replace-
ment,
Service
Call
Cut sheets
has press-
ing mark.
• The clamp pressure is too strong
for the sheets, or the support
plate is not attached. (Attach the
support plate on the clamp.)
-
Cut sheets
are stained
by grease.
• Excess grease may be filled.
(Wipe the filled grease at cutting
section.)
-
Knife
Sheet
Sheets
Diagonal Line on
the Cut Surface
Pressing Mark
Section likely
to be stained
WARNING
Turn off the power switch
before the operation.
Otherwise, sharp knife
can cause severe per-
sonal injury.