MyBinding Standard APC45 Programmable, Instruction Manual

Page: 43 / 54

35
Knife Ang
le Adjustme
nt
Rep
laceme
n
t and
Ad
justm
ent
4-2 Knife Angle Adjustment
Adjust the knife angle if part of the sheets
remain uncut as shown in the figure below.
If only bottom sheets remain uncut, the
problem can be improved also by low-
ering the knife position. Refer to “4-1
Knife Lower Limit Adjustment.”
Turn off the power switch.
Remove the knife cover.
- Loosen two screws and remove the knife
cover.
Turn on the power switch.
- The indication [REPLACE MODE] is shown
on the guide window and then it changes to
[LOWER CLAMP].
Press the cutting buttons and keep
pressing until you hear a beeping
sound.
- Release the cutting buttons after only the
clamp lowers and stops.
- The indication [TURN OFF POWER
REPLACE KNIFE] is shown on the guide win-
dow.
Turn off the power switch.
WARNING
• A single operator must perform the
adjustment.
• There will be some procedures to turn off
the power switch below. Make sure to turn
off the power switch. Otherwise, sharp
knife can cause severe personal injury.
Some Sheets at
the Bottom
Uncut
OFF
ON
Knife Cover
OFF
ON
KNIFE REPLACE MODE
LOWER CLAMP
TURN OFF POWER
REPLACE KNIFE
Cutting Buttons
Clamp
Knife