44
EN
M1.1.HB250CF.NLFREN - 05012018
• Operators will hear the sound when the safety claw falls on the safety strip in the case of normal use. If not, this machine
is prohibited to use. Operator can check the safety device by opening the decorated box. If the safety device is blocked,
adjust the screw on the safety claw till the sound can be heard when the safety claw falls on the safety strip.
• Only press “LOCK” button after the machine is lifted, vehicle maintenance can be permitted.
• If the two carriages are not in the same plane, adjust the nut on steel cable to keep them in the same plane. Tighten the
steel cable, or the two carriages can not be synchronous.
• Locking devices are installed in each lifting arm, it can lock automatically when lifting arm rotate to any needed angle.
When the carriage in the lowest position, the lifting arm can rotate freely. In order to prevent the lifting tray from falling, we
adopt the adjustable thread lifting tray to make it more safe and convenient.
Risk for extrusion
During up and down operations, personnel leave the work area.
During up and down operations, no person is admitted to work beneath the movable parts of the lift, should work in the
safe zone.
Risk of impact
Before the operator begins up and down movements, make sure that there are no personnel inside the danger zone.
When, due to operational reasons, the lift is stopped at relatively low elevations (lower than 1.75 m above the ground)
personnel must be careful to avoid impact with parts of the machine not marked with special colours.
Risk of falling (vehicle)
This hazard may arise in the case of incorrect positioning of the vehicle on the lifting arms, overweight of the vehicle, or
in the case of vehicles of dimensions that are not compatible with the capacity of the lift.
When the lifting arm is being tested, the vehicle engine can not be turned on.
There is nothing should be placed on the lift-lowering area and the movable parts of the lift.
Risk of slipping
The floor caused by lubricant contamination of around the lift. The area beneath and immediately surrounding the lift
and also the platforms must be kept clean. Remove any oil spills immediately.
Risk of electric shock
Risk of electric shock in areas of insulated and shattered electric equipments.
Do not use jets of water, steam solvents or paint next to the lift, and take special care to keep such substances clear of
the electrical control panel.
Risks related to appropriate lighting
The operator and the maintenance fitter must be able to assure that all the areas of the lift are properly and uniformly
illuminate compliance with the laws in force in the place of installation.
During up and down operations, the operator should continually observe the lift and can operate it only in the position
of operator. When lifting and lowering the vehicle, the cushion needs being put in the bottom of chassis.
The handling of safety devices is strictly forbidden� Never exceed the maximum carrying capacity
of the lift, make sure the vehicles to be lifted have no load�
copyrighted
document
- all
rights
reserved
by
FBC
