User’s Guide ViperTX Extreme
Basics
AP-75340 - Revision 1.0
43
3
ͬ»° éæ
Change
the step is necessary with
F2
ͬ»° èæ
Print the test pattern again until no gap or overlap is visible anymore.
Change the step on-the-fly
However it is recommended to determine the step before you start a job on a new fabric, it is
also possible to adjust the step while printing as follows:
ͬ»° ïæ
Press
F1
while printing.
ͬ»° îæ
Press
F2
or
F4
to change the step.
Raise the value when there are overlaps (underfeed)
Lower the value when there are gaps visible (overfeed)
ͬ»° íæ
Press
enter
to save the changes.
