Rockhopper II series printers – Maintenance Manual
234
AP-74065, Rev. 1.2, 27/09/04
7.12. HEAD HEIGHT ADJUSTMENT
This section explains the procedure for adjusting the head height.
If CR cursor assembly is changed, adjust head height.
7.12.1. Tools required for work
The following tools are required when adjusting the head height.
CR gap check jig
Notes :
¾
Refer to “Jig and Tool List".
7.12.2. Adjustment Procedure
Perform the head height adjustment following the procedures below.
Step 1 :
Unlock the head lock according to "Head Lock Menu".
Step 2 :
Move the CR cursor on the platen.
Step 3 :
Remove the head cover according to "Removing the head cover".
Step 4 :
Point slide gear mark down so that heads move into low position.
Step 5 :
Loosen the screws (2, one on the right, one on the left) that fasten the head U/D eccentric shaft
lever.
1 = Head U/D eccentric shaft lever
2 = Screws fixing the head U/D eccentric shaft lever
3 = Slide gear
4 = Slide gear triangular mark
Step 6 :
Put the CR gap adjusting jig on the platen.
Step 7 :
Move the CR cursor so that 1.2mm side of adjustment jig makes contact with the side of head.
Summary of Contents for Rockhopper II 2H
