MUTOH Rockhopper II 2H, Maintenance Manual, Page: 21 / 319

Rockhopper II series printers – Maintenance Manual
22 AP-74065, Rev. 1.2, 27/09/04
2.3 . PART NAMES AND FUNCTIONS
Part names and functions are explained below.
2.3.1. Front
No. Name Function
1 Operation panel This panel is used to set operational conditions, the status of the printer,
and other functions.
2 Ink compartment This is the place for installing ink cartridges.
3 Front cover This cover keeps the operator safe from the drive parts of the printer
while it is operating. Only open and/or close the cover to perform
following operations:
¾ Media setting and replacement
¾ Cutter blade replacement
¾ Cleaning the cleaning wiper
¾ In case of media jam.
4 Pressure rollers This roller is used to press the media from above and keep it flat when
printing.
5 Maintenance cover This protects users from electric shocks caused by touching the internal
electrical parts. The cover is opened when expansion memory
(optional) has to be installed, and is closed for normal use.
6 Stand This stand is used to install the printer on a surface flat floor.
The following options are available for installation.
¾ Take-up scroller receiver
¾ Motorized roll-off / roll-up system
7 Media cut groove Only onto the Rockhopper II 4H printer !
Used to cut the media straight when it is cut manually.
8 Carriage cover Only onto the Rockhopper II printer !
This is a cover to protect the user from the internal components of the
unit. This is opened during following operation :
¾ When cleaning the cleaning wiper
9 Foot switch This switch is used to raise and lower the pressure rollers.
10 Paper Guide Support the media during printing
In the Rockhopper II it houses post-heater (dryer).
In the Rockhopper II 4H it houses the fixer, post-fixer and dryer.