Murphy PowerCore MGC1000, Operation Manual

Page: 15 / 48

Software Release: [TBD]
Section 40 15 00-02-1167
2018-09-18
Setting to Auto Start on Clock
NOTES:
1)
Ensure the correct date and time are established in the System menu prior to
establishing the Auto Start on Clock settings.
2) The Clock start timer is independent of other auto start start/stop functions. When
started from the clock the controller will shut down the engine from the clock.
1. Access Menu/Start_Stop Timers , and select the first Start/Stop Timer.
2. Select Start Day 1 and then select the appropriate day or Daily.
3. Select Start Time 1 and establish the hour, minute and second to start.
4. Establish the Stop Day and Time as in steps 2-3.
5. Press the [Menu] key to exit the menu setup screens.
NOTE: The MGC1000 has the ability to establish three different Start/Stop dates and
times. If desired, repeat steps 1-3 for subsequent Timers.
Setting
up to Stop the Engine from Utilizing the Countdown
Timer
The MGC1000 will only utilize this timer when starting in Auto mode. The control and the running of the
engine will continue until the chosen stop condition is met or until the Countdown timer runs out of time.
Once set, the operator will be required to disable or change the timer in the menu in order to eliminate the
countdown timer being active on every auto startup.
1. Access Menu/Start_Stop Timers/Countdown Timer .
2. Set the hours, minutes and seconds desired for the running of the engine, and press
[Enter]
.
3. Press the
[Menu]
key to exit the menu setup screens.
NOTE: When the Countdown Timer is set for a countdown, the controller will always
countdown upon an auto start until the timer is set to 0.
Screen Examples
Figure 8: Screen Example