Multitech MultiVOIP 400, User Manual

Page: 24 / 88

24
MultiVOIP User Guide
9 The Default Setup dialog box is displayed.
Click YES to continue.
10 The IP Protocol Default Setup dialog box is displayed.
The default Frame Type is TYPE_II. If this does not match your IP network, change the Frame
Type by clicking on the drop down box. The Frame Type choices are TYPE_II and SNAP.
11 In the Ethernet group, enter the IP Address, Subnet Mask, and Gateway Address, unique
to your IP LAN, in the corresponding fields.
The IP address is your unique LAN IP address, and the Gateway address is the IP address of
the device connected to the Internet/Intranet.
Click OK when you are finished.
12 The Channel Setup dialog box is displayed. The Channel Setup dialog boxes define the
channel interface, voice coder, fax parameters, and regional telephone parameters for each
channel.
Configure each channel for the type of interface you are connecting to. The Interface tab
defaults to channel 1 in the Select Channel group. To change the channel number, click on
the down arrow for the Select Channel and a drop down menu appears with all the channels
displayed. Highlight the channel number you want to configure.
13 The Interface group defaults to FXS (Loop Start). Select the interface option to correspond
to the interface type being connected to the Voice/Fax connector on the back panel of the
MultiVOIP.
If you are connecting a station device, e.g., analog telephone, fax machine, or KTS telephone
system to the Voice/Fax connector on the back of the unit, the majority of the time the FXS
(Loop Start) will be the correct Interface option.