Multitech MultiVOIP 200, User Manual

Page: 39 / 97

39
Chapter 3 - Software Loading and Configuration
6 If you are connecting a station device (e.g., analog telephone, fax machine, or Key Telephone
System (KTS) to your MultiVOIP, connect the smaller end of a special adapter cable (sup-
plied) to the Voice/Fax Channel 1 FXS connector on the back of the MultiVOIP and the other
end to the station device.
If you are connecting a PBX extension to your MultiVOIP, connect the smaller end of a special
adapter cable (supplied) to the Voice/Fax Channel 1 FXO connector on the back of the
MultiVOIP and the other end to the PBX extension.
If you are connecting an E&M trunk from a telephone switch to your MultiVOIP, connect one
end of an RJ-45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the
MultiVOIP and the other end to the trunk phone jack. See connector drawing in Appendix B.
If you are connecting to an E&M trunk, you need to ensure that the E&M trunk jumper is in the
correct position for the E&M type trunk. The default E&M jumper position is E&M type 2. To
change the E&M jumper position, perform the E&M jumper block positioning procedure.
7 Repeat the above step to connect the remaining telephone equipment to each Voice/Fax
Channel on your MultiVOIP.
8 Turn on power to the MultiVOIP by placing the ON/OFF switch on the back panel to the ON
position. Wait for the BOOT LED on the MultiVOIP to go OFF before proceeding. This may
take a couple of minutes to go OFF.
9 At this time your VOIP network should be fully operational, dial one of the sites in your network
using the dialing directory supplied by your network Administrator.