Multitech MultiVOIP 200 MVP200, User Manual

Page: 72 / 113

72
MultiVOIP 200 User Guide
Upgrade Procedures
Whenever you upgrade your version of the MultiVOIP 200 software, you must first install the new
software on your PC. Then use the Upgrade Software function, or download the Firmware, the
Factory Defaults, the Voice Coders, and/or the H.323 stack to upgrade the MultiVOIP 200 itself.
Before starting the upgrade process, view the current configuration and write down important data
such as your IP address, and voice channel configurations; these settings must be put back in place
after the software has been upgraded. Multi-Tech also recommends that you use the Print button on
the Phone Directory Database dialog box to have a copy of the phone directory contents.
Four utility programs included in the MultiVOIP 200 software are to be used only after the unit has
been repaired or upgraded. They are
Upgrade Software, Download Firmware, Download Voice
Coders, and Download H.323 Stack.
Upgrade Software
Note: The software upgrade can only be done from the command port. It can not be done via a
network connection.
If you have obtained a new firmware version, Boot Code, Coders file, or H.323 stack from the Multi-
Tech Web site, the Multi-Tech FTP site, or another source, do the following:
From your desk top, click Programs | MultiVOIP 200 v2.52 | Upgrade Software. The Down-loading
Boot dialog box appears while the Boot Code upgrade is downloaded to the MultiVOIP 200.
When this is done, the unit will reboot and then enable you to set up your default setup on the
following two dialog boxes:
Enter your LAN IP address, mask, and gateway address in the IP Protocol Default Setup dialog box.
Click OK when you have finished.