Multitech MultiVOIP 200 MVP200, User Manual

Page: 21 / 113

21
Chapter 2 - Installation
If you are connecting a PBX extension to your MultiVOIP 200, connect the smaller end of a
special adapter cable (supplied) to the Voice/Fax Channel 1 FXO connector on the back of the
MultiVOIP 200 and the other end to the PBX extension.
If you are connecting an E&M trunk from a telephone switch to your MultiVOIP 200, connect one
end of an RJ-45 cable (not supplied) to the Voice/Fax Channel 1 E&M connector on the back of
the MultiVOIP 200 and the other end (8 spade lugs or 8 wires to connect directly to the punch-
down block) to the PBX trunk card.
If you are using a Magix 400 E&M Tie Card, connect the ground pin to the chassis ground screw
as shown.
6
3
1
4
5
2
1
2
3
4
5
6
7
8
Male Male
PIN NO. PIN NO.
MVP 200
Connection
Magix 400 E&M 4
Wire Tire Card
M MOUTH CONTROL
E EAR CONTROL
T1 TIP 1 RECEIVE
R RING TRANSMIT
T TIP TRANSMIT
R1 RING 1 RECEIVE
CHASSIS GROUND SCREW
UNUSED
M I N P U T
E O U T P U T
T 1 4 - W I R E O U T P U T
R 4 - W I R E I N P U T , 2 - W I R E
T 4 - W I R E I N P U T , 2 - W I R E
R 1 4 - W I R E O U T P U T
S G ( S I G N A L G N D ) O U T P U T
S B ( S I G N A L B A T T E R Y O U T P U T
Note: For customers building their own E&M connector, Appendix B has a pinout diagram
showing the E&M back panel connector on the MultiVOIP 200.
5. Repeat step 4 to connect the remaining telephone equipment to each Voice/Fax Channel on your
MultiVOIP 200.
6. Turn on power to the MultiVOIP 200 by setting the power switch on the back panel to the 1 (up,
On) position. Wait for the Boot LED on the MultiVOIP 200 to go Off before proceeding. This may
take a couple of minutes.
If you need to change the E&M Jumper Block positioning, refer to the following section; otherwise,
proceed to the Chapter 3, Software Loading and Configuration, to load the MultiVOIP 200 software.