Multitech MultiModem MT2834ZPW, Owner'S Manual

Page: 47 / 94

Chapter 5 - Controlling Your Modem
47
Result Codes
In command mode the MT2834ZPW sends result codes to your
computer to provide you with on-going information during dialing and
connection. The following table shows the available result codes.
Terse Verbose Description
0 OK Command executed
1 CONNECT Modem connected to line
2 RING
Ring signal detected
3 NO CARRIER
Carrier signal lost or not detected
4 ERROR Invalid command
5 * CONNECT 1200 Connected at 1200 bps
6 NO DIALTONE No dial tone detected
7 BUSY Busy signal detected
8 NO ANSWER No answer at remote end
10 * CONNECT 2400
Connected at 2400 bps
11 * CONNECT 4800
Connected at 4800 bps
12 * CONNECT 9600 Connected at 9600 bps
13 * CONNECT 14400
Connected at 14400 bps
14 * CONNECT 19200 Connected at 19200 bps
24 * CONNECT 7200 Connected at 7200 bps
25 * CONNECT 12000 Connected at 12000 bps
26 * CONNECT 16800 Connected at 16800 bps
40 * CONNECT 300 Connected at 300 bps
55 * CONNECT 21600
Connected at 21600 bps
56 * CONNECT 24000
Connected at 24000 bps
57 * CONNECT 26400 Connected at 26400 bps
58 * CONNECT 28800 Connected at 28800 bps
59 * CONNECT 31200 Connected at 31200 bps
60 * CONNECT 33600 Connected at 33600 bps
88 DELAYED Delay is in effect for the dialed number
89 BLACKLISTED
Dialed number is blacklisted
90 BLACKLIST FULL
Blacklist is full
*
EC
is added to these result codes when the extended result codes configuration option
is enabled. EC is replaced by one of the following codes, depending on the type of error
control connection:
V42bis
(V.42 error control [LAP-M] and V.42bis data compression);
V42 (V.42 error control [LAP-M] only); MNP5 (MNP 4 error control and MNP 5 data
compression);
MNP4
(MNP 4 error control only);
NoEC
(No error control protocol).