Multitech MultiModem MT2834ZPW, Owner'S Manual

Page: 37 / 94

Chapter 5 - Controlling Your Modem
37
Command: L n Monitor Speaker Volume
Values:
n = 0, 1, 2, or 3
Default: 2
Description: L0 Select low volume.
L1 Select low volume.
L2 Select medium volume.
L3 Select high volume.
Command: M
n
Monitor Speaker Mode
Values:
n = 0, 1, 2, or 3
Default: 1
Description: M0 Speaker always off.
M1 Speaker on until carrier signal detected.
M2 Speaker always on when modem is off-hook.
M3 Speaker on until carrier is detected, except while dial-
ing.
Command: N
n
Modulation Handshake
Values: n = 0 or 1
Default: 1
Description: N0 Modem performs handshake only at communication
standard specified by S37 and the
B command.
N1 Modem begins handshake at communication standard
specified by S37 and the
B command. During hand-
shake, fallback to a lower speed can occur.
Command: O Return Online to Data Mode
Values: 0, 1, 3
Default: None
Description: O0 Exit online command mode and return to data mode.
O1 Issue a retrain and return to online data mode.
O3 Issue a rate renegotiation and return to data mode.
Command: Q n Result Codes Enable/Disable
Values: n = 0 or 1
Default: 0
Description: Q0 Enable result codes.
Q1 Disable result codes.