![background image](http://html1.mh-extra.com/html/multiquip/ls600p/ls600p_operation-manual_1855382074.webp)
MAYCO LS600P CONCRETE PUMP • OPERATION MANUAL — REV. #1 (09/09/19) — PAGE 73
TROUBLESHOOTING (PUMP)
Troubleshooting (Pump)
Symptom
Possible Problem
Solution
Main Hydraulic Cylinder will
not cycle
Incorrect System Operating Pressure Check the pump pressure gage. Verify it is
approx. 4400 PSI
Incorrect Engine RPM setting
Verify the engine's high RPM speed is set to
2550
Contaminated Main Relief Valve
Check the manifold for a contaminated Relief
Valve
Obstructed Material Cylinders
check for obstructions (dried material) inside
the cylinders
Hopper Remix Paddles will
not rotate
Incorrect Directional Control
Operating Pressure
Verify the Directional Control operating
pressure is approx. 1000 PSI
Contaminated Relief Valve
Check the manifold for a contaminated Relief
Valve
Broken Shaft Coupler Key
Check the Hopper Remixer shaft coupler for a
broken key
Loose Shaft Retaining Set Collar
Check the Shaft Retaining Set Collar for
tightness
Shuttle Cylinder does not
stroke
Incorrect Accumulator
SystemPressure
Check the system pressure reading. Verify it is
approx. 1750 PSI
Contaminated Relief Valve
Check the manifold for a contaminated Relief
Valve
Swing Solenoid not engergizing
Check for burned out solenoid and 12V signal
voltage
Swing Valve not functioning properly
Manually cycle the pump using the manual
cylinder jogging switch
Shuttle Cylinder slow to
complete stroke
Improper Flow Control setting
Fully open Flow Control Vave
Incorrect Engine RPM setting
Verify the engine's high RPM speed is set to
2550
Incorrect Main Hydraulic
System Operating Pressure
Check the pump pressure gage. Verify it is
approx. 3200 PSI
Contaiminated Swing Relief Cartridge Check the manifold for contaminated Swing
Relief Cartridge
Low Accumulator System Pressure
Check the accumulator pressure reading. Verify
it is approx. 1750 PSI
Hopper Discharge Nipple Seal
improperly lubricated
Check the Hopper Discharge Nipple Seal for
siezing and lack of lubricant
Concrete slurry in
lubrication box
Worn or defective urethane cups or
worn material cylinder
Replace
Material cylinder piston
cups squeel
Low on lubrication
Check oil level
To order go to Discount-Equipment.com