![background image](http://html1.mh-extra.com/html/multiquip/ls600p/ls600p_operation-manual_1855382044.webp)
PAGE 44 — MAYCO LS600P CONCRETE PUMP • OPERATION MANUAL — REV. #1 (09/09/19)
Fuel Filter
Replace the secondary fuel filter (Figure 48) every 800
hours. Refer to your engine manual for specific details to
perform this operation.
Figure 48. Fuel Filter
Fuel/Water Separator Primary Filter
1. Inspect the fuel filter water separator daily. If the fuel
filter/water separator (Figure 49) has collected a
significant amount of water and sediment at the bottom
of the cup, it should be drained off.
Figure 49. Fuel Water Separator
2. To remove water and sediment from the cup, place
any fuel valves to the
OFF
position and unscrew the
cup from the base.
3. Pour the contents of the cup into a safety container.
Rinse cup with a mild detergent and reattach cup to
base.
4. Return fuel valves to the
ON
position.
DRAIN
CUP
SEDIMENT
CUP
DRAIN
MAINTENANCE
In-Line Fuel Filter
Replace the engine in-line fuel filter (Figure 50) every year or
300 hours.
Figure 50. In-Line Fuel Filter
Oil And Fuel Lines
1. Check the oil and fuel lines and connections regularly
for leaks or damage. Repair or replace as necessary.
2. Replace the oil and fuel lines every two years to
maintain the line's performance and flexibility.
V-BELT
Visually examine the V-belt (Figure 51) and determine if it
is full of tiny cracks, frayed, has pieces of rubber missing,
is peeling or otherwise damaged.
Also, examine the belt and determine if it is
oil soaked
or
"
glazed
" (hard shiny appearance on the sides of the belt).
Either of these two conditions can cause the belt to run hot,
which can weaken it and increase the danger of it breaking.
If the V-belt exhibits any of the above wear conditions
replace the V-belt immediately.
Figure 51. Drive Belt Inspection
GLAZED
OIL SOAKED
BROKEN
CORD FAILURE
CRACKS
MISSING RUBBER
SIDEWALL
WEAR
WORN BACK
COVER
To order go to Discount-Equipment.com