![background image](http://html1.mh-extra.com/html/multiquip/ls600p/ls600p_operation-manual_1855382033.webp)
MAYCO LS600P CONCRETE PUMP • OPERATION MANUAL — REV. #1 (09/09/19) — PAGE 33
OPERATION
Starting Procedure
1. Locate the
emergency stop switch
(Figure 20) on
the
digital control panel
. Turn the emergency stop
switch clockwise and release (open). This will allow
the engine to start.
Figure 20. Emergency Stop Switch
2. Place the
cylinder stroke control switch
in the
AUTOMATIC
position (Figure 21).
Figure 21. Cylinder Stroke Control Switch
(Automatic)
3. Place the
pumping control switch
in the
CENTER
OFF
position (Figure 22) for normal pumping operation.
Figure 22. Pumping Control Switch (OFF)
WARNING
DO NOT
attempt to operate this concrete pump until
the Safety, General Information and Inspection sections
have been read and understood.
E
m
erg
ency S
top
NOTICE
If the
emergency stop switch
is in the closed position
(
STOP
), engine will not start. To start the engine, make
sure the emergency stop switch is in the
OPEN
position
(fully extended).
AUTOMATIC
JOG
LOCAL
REMOTE
CENTER
OFF
4. Place the
direction control switch
to the
FORWARD
Figure 23. Direction Control Switch
(FORWARD)
5. To start the engine, insert the ignition key (Figure 24)
into the ignition switch and turn the key to the
ON
position.
Figure 24. Ignition Switch
6. When the ignition key is in the
ON
position, the
digital
readout screen
(primary) will cycle through 3 displays
as shown in Figure 25.
Figure 25. Primary Screen (Ignition Key ON)
7. Turn the key to the
START
position and listen for the
engine to start. In warm weather let engine warm up
for 5 minutes. In cold weather, let engine warm up for
10 minutes.
FORWARD
REVERSE
IGNITION
ON
OFF
START
LS 600 OFF
0000 ENG RPM
BATTERY 12.5 V
LOW OIL PSI
1
LS 600 OFF
0000 ENG RPM
BATTERY 12.5 V
LOW RPM FAULT
1
LS 600 OFF
0000 ENG RPM
BATTERY 12.5 V
END OF MESSAGE
1
To order go to Discount-Equipment.com