![background image](http://html1.mh-extra.com/html/multiquip/ls600p/ls600p_operation-manual_1855382038.webp)
PAGE 38 — MAYCO LS600P CONCRETE PUMP • OPERATION MANUAL — REV. #1 (09/09/19)
Radio Remote Control Programming
Before starting operation of the hand-held
radio remote
control
, go to Screen 9 of the
digital readout screen
:
Screen 9
1. Press the
ON/OFF
button on the radio (wireless)
remote control to turn on the power. Hold down the
RESET
switch. The display will now show.
Screen 9
2. After 5 seconds, the display will show:
Screen 9
3. The hand-held remote control module is now ready
for use.
RADIO ADDRESS
NO RADIO
PRESS RESET TO
LEARN A NEW ONE
9
RADIO ADDRESS
NOW SCANNING
FOR NEW
TRANSMITTER
9
RADIO ADDRESS
COMMUNICATING
PRESS RESET TO
LEARN A NEW ONE
9
Remote Control Cable Operation (25 ft.)
The remote control cable (Figure 40) has the following
controls:
Pump ON/OFF
– Starts and stops the forward pumping.
Pump REV
– Starts pumping in reverse direction.
Connect the
remote control cable
(Figure 40) to the
receptacle labeled
remote
located on front of the digital
panel.
Figure 40. Remote Control Cable
Before the remote control cable can be used the pumping
volume rate must be set.
1. Start the pump as outlined in the pumping section of
this manual.
2. Place the
pumping control switch
in the
LOCAL
position.
3. Using the momentary volume control switch, adjust
the pumping rate (volume) to the desired strokes per
minute.
4. Once the desired pumping rate has been acheived,
place the
pumping control switch
in the
REMOTE
position.
REMOTE CONTROL CABLE UNIT
25 FT. CABLE
PUMP REV
PUMP ON/OFF
TO CONTROL BOX
CONNECTOR
OPERATION
To order go to Discount-Equipment.com