![background image](http://html1.mh-extra.com/html/multiquip/ls600p/ls600p_operation-manual_1855382023.webp)
MAYCO LS600P CONCRETE PUMP • OPERATION MANUAL — REV. #1 (09/09/19) — PAGE 23
Figure 5 and illustrates the location of the major
components for the LS600P Concrete Pump. The function
of each component is described below:
1.
Tow Hitch Coupler
— Requires a 2-inch ball hitch or
a 3-inch pintle. Capable of towing 8,000 lbs.
2.
Radio Control Antenna
— Mounting location for radio
control antenna. Works in conjunction with hand-held
radio remote (option).
3.
Manifold Access Door
— Release latch and lift door
to access the hydraulic manifold block.
4.
Hydraulic Oil Reservoir Access Cover
— Remove
this cover to gain access to the hydraulic oil tank for
maintenance/cleaning.
5.
Hydraulic Manifold Block
— Manifold block
that controls the flow of hydraulic pressure to the
components required to control the pump.
6.
Shuttle Cylinder/Guard
— Under pressure, the
shuttle cylinder shears concrete passing from the
concrete cylinder to the delivery line during the cycle
phase.
ALWAYS
keep hands clear from shuttle cylinder
during operation.
7.
Rear Pumping Jack Stand
— Use this jack stand
to level and support the rear end of the pump during
operation.
NEVER
deploy on un-level ground and
always check for firmness of ground.
8.
Tires
— This trailer uses two ST235/80R16 type tires.
Tire inflation pressure is the most important factor in
tire life. Pressure should be checked to 80 psi cold
before operation.
DO NOT
bleed air from tires when
they are hot. Check inflation pressure weekly during
use to insure the maximum tire life and tread wear.
9.
Fuel Tank/Cap
— Fill with diesel fuel. Fuel tank (cell)
holds approximately 40 gallons (176 liters).
DO NOT
top off fuel. Wipe up any spilled fuel immediately.
10.
Battery
— This unit uses a +12 VDC type battery.
ALWAYS
use gloves and eye protection when handling
the battery.
11.
Fuel Tank (Cell) Access Cover
— Remove this cover
to gain access to the fuel tank for maintenance/cleaning.
12.
Parking Jack Stand
— Use this jack stand to level
and support the tow end of the pump.
13.
Front Pumping Jack Stand
— Use this jack stand
to level and support the rear end of the pump during
operation.
NEVER
deploy on un-level ground and
always check for firmness of ground.
14.
Safety Chains
— This pump uses 5/16-inch thick,
72 inches long zinc-plated saftey chains.
ALWAYS
connect safety chains when towing.
PUMP COMPONENTS
To order go to Discount-Equipment.com