Multilin SR469, Instruction Manual

Page: 266 / 270

SR469 MANUAL
INDEX
reverse power 4-61
RS232 3-3, 4-6, 6-1
RS485 2-17, 4-6, 6-1
RTD 2-13, 4-38, 5-9, 5-16
ambient 4-52
bearing 4-50
bias 4-37
maximums 4-8, 4-14, 5-16
other 4-51
short/low temp 4-53
stator 4-49
types 4-48
RTD accuracy test 7-4
running hours 4-14
S
secondary injection test setup 7-1
serial communication
control 4-12
serial ports 4-5
service relay 2-16
setpoint entry 3-5
setpoint file
creating 8-5
downloading 8-7
editing 8-6
upgrading 8-8
setpoint message map 4-3
short circuit 4-39
short circuit test 7-13
simulate fault See digital input functions
simulate pre-fault See digital input functions
simulate pre-fault...fault See digital input functions
simulation mode 4-72
single line 1-1
single phasing 4-42
specifications 1-4–1-7
speed 5-10
Speed 2 acceleration 4-79
Speed 2 undercurrent 4-79
speed switch trip See digital input functions
SR469 display 3-2
SR469 faceplate 3-1
SR469 keypad 3-4
SR469 LED indicators 3-2
standard overload curve 4-26, 4-27
standard overload curves 4-28, 4-29
start block 5-6, 5-23
start block relay 2-16
start inhibit 4-45
starter
failure 4-63
information 4-9
operations 4-14
status 4-15
status switch 4-13
starting current 4-9
starting thermal capacity 4-9
starts/hour 4-46
starts/hour block 4-14
Stator RTD 4-49
system frequency 5-10
T
tachometer 5-10. See digital input functions
temperature 5-9
temperature display 4-5
terminal layout 2-5
terminal list 2-6
test analog output 4-75
test output relays 4-75
test switch 4-14
thermal capacity used 4-25, 4-45, 5-2
thermal model 4-25
time between starts 4-14, 4-46
timers 5-19
timing 6-4
trending 8-10
trip coil supervision 7-6
trip counter 4-8, 4-62, 5-18
trip relay 2-16
trips 4-1
troubleshooting 8-17
two-speed motor 2-18, 4-15, 4-77
U
unbalance 4-42, 5-8
unbalance bias 4-25, 4-35
unbalance test 7-11
undercurrent 4-41
underpower 4-60
undervoltage 4-54
upgrade 8-1
user definable memory map area See memory map
V
vibration 2-12
vibration switch alarm See digital input functions
vibration switch trip See digital input functions
voltage dependent overload 4-27, 4-31, 4-32, 4-33, 4-34
voltage input accuracy test 7-2
voltage inputs 2-11
voltage metering 5-10
voltage phase reversal test 7-12
voltage sensing 4-10
W
waveform capture 6-15, 8-12, 8-14, 8-15
wiring 2-7
wye 2-11
Z
zero sequence 4-10