4
Mounting and installation
Installing sensors on the slurry tanker
16
V4.20191001
30322453-02-EN
7.
Close the screw connections of the junction box.
After screwing them shut, the glands should be sealed.
8.
Close unused openings in the casing of the junction box with blind caps.
Inserting the cable core into a terminal
Each terminal consists of two openings:
▪
The upper opening of the terminal opens the lower opening.
▪
The bottom opening of the terminal serves to insert and clamp one cable core.
You have prepared a small flat screwdriver that fits the upper opening of the terminal. You only
need this screwdriver if there are no wire end sleeves on the cable cores.
You have cut the cable to the proper length and have exposed the cable cores according to the
instructions, or you have a finished cable from Müller Elektronik.
The tractor engine is switched off.
The junction box is not powered.
There is no voltage on the components to be connected.
1.
Find the proper connectors for the cable cores to be connected.
To do so, use the information on the lid of the junction box, on the relay circuit board and in the
pin-out diagram.
2.
Insert the cable core into the opening in the lower part of the terminal. If you are not using wire
end sleeves, you first have to use the screwdriver.
⇨
The cable core will be held by the terminal.
⇨
You have clamped the cable core.
Connecting the junction box to the job computer
1.
Connect the AMP connector of the junction box onto the proper job computer.
Installing sensors on the slurry tanker
The following sensors can be installed on the slurry tanker:
Purpose
Sensor type (according to the operating
mode)
Rotational speed sensor
Inductive sensor
Speed sensor
Position sensor (e.g. working position)
Reed contact sensor
Pressure sensor
Digital pressure sensor
Flow meter
Magnetic inductive liquid flow meter
4.3.2
Procedure
4.3.3
Procedure
4.4
