Configuring the job computer for work
Configuring the tank
7
30322453-02-EN
V4.20191001
51
“Fold/Unfold” parameter
Enter the driving speed up to which the mounted implement can be folded or unfolded. You only need
this parameter if you are using a mounted implement with a boom.
Configuring the tank
Use the following parameter on the “
SETTINGS
” screen for the configuration:
“Tank Size” parameter
Enter the tank capacity.
“Alarm Fill Level” parameter
Enter the fill level for the tank below which an alarm should appear.
“Min Auto Speed” parameter
Enter the minimum driving speed that must be reached to start the rate control.
Regardless of whether a minimum driving speed has been set or not, a started sequence will still be
executed.
“Delay - Level Sensor” parameter
Enter the time for which the sensor must detect that the tank is full before the display on the terminal
is adjusted. This prevents the display from changing between full and not full if there are fluctuations
in the tank while filling.
“Correction Factor” parameter
Enter a factor with which the current tank content should be multiplied.
Only use this parameter if the displayed tank content does not correspond to the actual tank content.
The standard set value is “1.000”.
Configuring the units
You can configure all of the units that are displayed on the terminal. You can select between various
metric and imperial units.
1.
On the work screen, press:
> (
) >
⇨
The “
UNITS
” screen appears.
⇨
On the screen, you will see which categories and subcategories can be configured.
2.
Enter the settings required.
7.6.4
7.7
7.7.1
7.7.2
7.7.3
7.7.4
7.7.5
7.8
Procedure
