952.5-0000010 OM
21
To the figure 2.1.1 – Layout of controls and instruments of the tractor:
1 – sun visor; 2 – handle to control the cab heater valve; 3 – place for radio receiver (car
stereo) installation; 4 – deflectors; 5 –recirculation shutters; 6 – windscreen wiper switch; 7 – cab
heater fan switch; 8 – rear lights switch; 9 – switch of front lights on the cab roof; 10 – „Road-train“
light switch (design variant); 11 – rear view mirror; 12 – emergency flashing switch; 13 – multifunc-
tional underwheel switch; 14 – instrument board; 15 – pilot lamps unit; 16 – integrated indicator; 17
– steering wheel; 18 – integrated indicator control panel; 19 – starter and instruments switch; 20 –
accumulator battery remote disconnect switch; 21 – windscreen washer switch; 22 – central light
switch; 23 – switch of front lights mounted on handgrips switch; 24 – clutch control pedal; 25 –
control lever of speed increase unit; 26 – handle for steering rake tilt fixation; 27 – left brake con-
trol pedal; 28 – right brake control pedal; 29 – accelerator pedal; 30 – engine control board; 31 –
cab lamp with switch; 32 – range shifting lever of gearbox; 33 – gear shifting lever of gearbox;
34,35,36 – levers to control hydrosystem outlets; 37 – parking brake control lever; 38 – FDA drive
control lever; 39, 40 – RLL hydrohoist control levers; 41 – console to control rear axle DL and rear
PTO; 42 – handle to control fuel supply.. 43 – limiter for the position control lever; 44 – handle to
switch between the ground-speed and continuous drives of PTO; 45 – rear screen wiper switch;
Instead of electrohydraulic control of rear axle DL and rear PTO, control system of rear
lift linkage with hydraulic lift your tractor can be optional equipped with mechanical control of
rear axle DL and rear PTO, with control system of RLL with draft control unit.
Also your tractor can be additional equipped with the following:
- instead of fan-heater an air-conditioner can be mouted;
- instead of double-lever GB control an single-lever GB control can be mounted;
- instead of speed increase unit an reverse gear unit can be mounted;
- instead of HLL outputs control with a help of levers optional can be mounted HLL
outputs control with joystick and lever;
- creeper installation is possible.
2.2 Switches of instrument board
1 – switch of front working lights, mounted on handgrips; 2 – emergency flashing
switch; 3 – multifunctional underwheel switch; 4 – starter and instruments switch; 5 – ac-
cumulator battery remote switch; 6 – windscreen washer switch; 7 – central light switch.
Figure 2.2.1 – Switches of instrument board
The starter and instruments switch 4 (see fig. 2.2.1) has four positions:
- «0» – off;
- «I» – instruments; pilot lamps unit, heating plugs are on;
- «II» – starter is on (non-fixed position);
- «III» – radio set is on.