952.5-0000010 OM
110
4.4.2 Drawbar hitch DH-2V (short towing yoke)
Figure 4.4.1 – Installation variants scheme of DH-2V
(short towing yoke)
Table 4.2 – Basic parameters and coupling dimensions of DH-2V (short towing
yoke)
Standard size (configuration)
DH-2V (short towing yoke)
1 Variant
Yoke acc. to ISO
1 Variant
2 Mounting location
Rear lifting device
3 Design features
Non-rotational, height adjustable
4 Purpose
For connection and coupling of trailed,
semi-trailed implements with traveling
wheels including of tractor semi-trailer type
40
85
5 DH yoke dimensions, mm:
а
) connecting pin diameter
b) yoke gap height
c) yoke gap width
70
d) yoke position
1
for the implements driven by rear
PTO shaft
Lowermost position, as shown in figure
4.4.1
e) distance between PTO shaft end extension and con-
nection pin axis, mm
110
160
6 Trailing appliance for connection to DH:
а
) type
Rigid, with tractor drawbar clevis
b) vertical load in hitch point, kN, not more than
20
c) trailing appliance steering angle in horizontal plane,
degrees, not less than
±60
d) protective mean type
Safety chain (rope)
2)
e) connection point of protective mean to the tractor
Lifting device bore
______________________________________________________________________________
___________________
1)
Recommended.
2)
Implement
accessories
ATTENTION: IT IS FORBIDDEN TO PUT DH-2V YOKE TO A POSITION WHERE
ITS BODY OVERHANGS THE DH SUPPORTING BRACKET END FOR MORE THAN
15
ММ
!