952.5-0000010 OM
122
The floating drawbar, both being part of combined drawbar and separately mounted
has following installation variants:
- two length positions;
- three positions in diametric plane;
To change position along the length it is necessary:
- remove pin 6 (figure 4.4.13) from bracket 10;
- move floating drawbar assembly until the second hole of the clevis 1 of floating
drawbar matches the hole in bracket 10;
- fix new floating drawbar position with pin 6.
For removal of implement axle relating to tractor axis floating drawbar 2 (figure
4.4.14) can be installed except main position in position at an angle of (4±1)º relating to the
longitudal tractor axle:
- po(4±1)º relating to the tractor axle – floating drawbar 2 is fixed by pins 1,
put into holes A of bracket 3;
- main position – floating drawbar is fixed by pins 1, put into holes B of bracket 3;
- position -(4±1)º relating to the tractor axle – floating drawbar is fixed by pins 1,
put into holes C of bracket 3.
1 – pin; 2 – floating drawbar; 3 – DH bracket.
Figure 4.4.14 – Installation variants of floating drawbar relating to longitudal tractor axis
B
C
B
C
