MTU 12V4000C*5 series, Operating Instructions Manual

Page: 17 / 305

1.6 Fire and environmental protection, fluids and lubricants
Fire prevention and fire
Fire, naked light and smoking are prohibited.
In case of a fire, stop the fuel supply if this is possible without endangering personnel.
The product has hot surfaces that can ignite combustible gases and other substances in the immediate area.
The operating company must install and operate the product a safe distance away from danger sources and
observe any relevant safety regulations or recommendations. Products that comply with the SOLAS Conven-
tion do not constitute such as danger.
After working with combustible fluids and lubricants (e.g. cleaning agents), ensure the area is well ventilated.
The resultant steam/air mixture must be sufficiently diluted to prevent a potentially explosive atmosphere.
Eliminate leaks of fluids and lubricants immediately. Fluids and lubricants on hot components can cause
fires, so keep the product clean at all times. Do not leave rags saturated with fluids and lubricants on the
product. Do not store combustible materials near the product.
Incorrect refueling of the reducing agent system with fuel can result in fire.
Before welding, clean the area to be welded with a nonflammable fluid. Do not carry out welding work on
pipes and components carrying oil or fuel.
When starting the engine with an external power source, connect the ground lead last and remove it first. To
avoid sparks in the vicinity of the battery, connect the ground cable from the external power source to the
ground cable of the engine or to the ground terminal of the starter.
Ensure that suitable extinguishing agents (fire extinguishers) are always available and that staff are familiar
with their correct handling.
A fire can result in the creation of toxic substances. Always wear protective gloves when handling compo-
nents and wear additional personal protective equipment is necessary.
Noise
Wear ear protectors in workplaces with a sound pressure level in excess of 85 dB (A).
Noise can lead to an increased risk of accidents if acoustic signals, warning shouts or sounds indicating dan-
ger are compromised.
Environmental protection and disposal
Dispose of used fluids, lubricants and components in accordance with local regulations.
Within the EU, batteries can be returned free of charge to the manufacturer where they will be properly recy-
cled.
Fluids and lubricants/auxiliary materials (process materials)
Process materials can also be or contain hazardous or toxic substances. When using process materials and
other chemical substances, observe the associated safety data sheet. The safety data sheet may be obtained
from the relevant manufacturer or from MTU.
Only process materials approved by the manufacturer in accordance with the Fluids and Lubricants Specifi-
cations must be used. The most recent respective version must be requested from the manufacturer.
Contamination of process materials with reducing agent (e.g. AdBlue ® , DEF): Store process materials in sep-
arate containers and their own drip trays. Even extremely small amounts of reducing agent contamination
can result in malfunctions in sensors and other components.
Used oil contains combustion residues that are harmful to health.
When handling used oil, protective gloves must be used.
Wash relevant areas after contact with used oil.
MS15041/03E 2018-08 | Safety | 15
TIM-ID: 0000040536 - 018