068 – SS T-Coolant
Red alarm. Engine shutdown.
Associated parameter 2.0120.932
Cause
Corrective action
Coolant temperature after engine
too high (limit value 2). Engine
coolant pump failure, volumetric
flow too low, air in engine coolant
circuit.
u
Check engine coolant circuit.
089 – SS Engine Speed too Low
Red alarm. Engine shutdown.
Associated parameter 2.2500.030
Cause
Corrective action
Engine stalls. In normal operation
the engine speed is below the
limit set in parameter 2.2500.027
(Engine stall speed limit) without
an engine stop having taken
place. The engine is shutdown for
safety reasons.
1. In parallel operation connected to mains:
• Check mains for frequency drop.
• Check generator and coupling for damage.
2. In isolated operation:
• Check throttle position.
• Check throttles for implausible closing. If throttles are fully
open: Check if load step values are admissible.
• Check bypass position.
• Check air filter for contamination, replace if contamination is
visible (→ Page 151).
• Check exhaust back pressure.
• Check differential pressure over mixture cooler.
• Check emissions and injection timing (→ Page 140).
• Check oil separator efficiency (oil in compressor intake elbow),
clean compressor if necessary.
• Check valve clearance (→ Page 141).
• Check gasket between mixture line and cylinder head for
correct installation position.
090 – SS Idle Speed Not Reached
Red alarm. Start terminated.
Associated parameter 2.1090.925
Cause
Corrective action
Idling speed not attained
1. Check ignition.
2. Check gas supply.
3. Check mixture setting.
091 – SS Release Speed Not Reached
Red alarm. Start terminated.
Associated parameter 2.1090.924
Cause
Corrective action
The speed (starter DISENGAGE)
was not attained, ignition not
working or no gas available.
1. Check ignition.
2. Check gas supply.
3. Check mixture setting.
MS150098/02E 2016-11
| Troubleshooting | 97
TIM-ID: 0000027858 - 001
