•
Allow the engine to run at suction for about 1-3 minutes to reach
operating temperature. Then smoothly turn off the suction (set its
lever to "OFF" position) and set the desired engine speed with the
throttle lever - moving the lever in the direction of the turtle
pictogram decrease the speed, and in the direction of the hare
pictogram increase it.
3.3.4
Turning the engine off
•
Set the throttle lever to the lowest engine speed and let the
engine run on it for at least one minute.
•
(MSW-GE70 only): Turn the ignition switch to the "OFF" position -
the engine will stop.
•
(MSW-GE70E only): Turn the ignition switch to the "OFF" position
- the engine will go out.
•
In case of further non-use, close the fuel valve by moving its lever
to the "OFF" position.
3.3.5
TRANSPORT AND STORAGE
If the equipment is not to be used again, cool it down completely
before transporting. For transport, it is advisable to empty the fuel
tank to prevent any fuel leakage during transport. Transport the
engine in an upright position (e.g. with the filler cap facing upwards).
If the unit is not used for a period of 1-2 months, empty the fuel from
the tank or pour fresh fuel and add stabilizer to it. If the unit is not
used for more than a few months, additionally empty the carburetor
of fuel (sink tank) and drain oil from the engine. Do not keep fuel in
the tank with stabilizer longer than recommended by the
manufacturer of this additive.
3.4.
Cleaning and maintenance
a)
Before cleaning, adjustment, replacement of accessories, and when the unit is
not in use, turn off the engine and cool the unit completely.
•
Wait until the rotating parts stop.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d)
Do not spray the unit with a stream of water or immerse it in water.
e)
Make sure that no water enters through the ventilation openings in the casing.
f)
Clean the ventilation openings with a brush and compressed air.
Summary of Contents for MSW-GE70
