MSH equipment CA Eco 40, User Manual

Page: 15 / 34

15 Eco 40-55-75 manual revision 01/10
5.4 OPERATING MODES
After commissioning you can use the machine, no operator intervention is necessary.
5.5 JOB END
The procedure for a voluntary Stop is as follows:
Open the main switch on control panel QSI installed by the customer (OFF position);
Open the main switch on machine control panel;
3. Close compressed air supply cock.
5.6 DECOMMISSIONING
In case of long periods of inactivity or in case of maintenance, user shall compulsorily:
•
Open and padlock the main switch QSI on main control panel (see Figure 6.1 A);
•
Close and lock compressed air inlet valve (see Figure 6.1.B);
•
Release circuit air by opening the condensate drain cock;
•
Put out a panel reading "EXHAUSTER BEING SERVICED".
6 MAINTENANCE
6.1 MACHINE CUT-OFF
Before attempting any maintenance or repair job,
user must cut all Exhauster supplies, proceeding as
follows:
1.
Open and padlock the main switch on main
control panel (6.1A).
2. Close and padlock the compressed air supply
and open the condensate drain cock to drain
the system (6.1B).
6.2 SPECIAL PRECAUTIONS
When carrying out maintenance or repair jobs, it is
recommended to proceed as follows:
•
Before starting, put out a panel reading
"EXHAUSTER BEING SERVICED" in a visible
position.
•
Do not use solvents and flammable materials;
•
Do not release lubricants into the environment;
•
Machine parts are not designed to bear a person's weight; do not stand on them or they could break.
•
When job is completed, restore and correctly fasten all protections and guards previously removed or
opened, as well as any safety device, if previously disabled.
6.1A 6.1B