MS ENERGY c10, Instruction Manual

Page: 367 / 404

ENG
20
Display light brightness auto adjustment
When brightness of surrounded environment changed, it will adjust brightness of display
backlight automatically through built-in photosensitive sensor. When the external
environment is getting darker, backlight brightness will become dimmed, also it will turn
bright when backlight brightness become brighter.
After turn on light automatically and press "
Headlight" button to turn off light and
photosensitive function, re-open display and restore photosensitive function.
Error Code Info
If there is a problem with the electronic system, an error code will appear automatically.
When an error appears, please check the corresponding part of e-bike or contact
authorized service.
Error Code Definition Solution
21
Current failure
Check whether the three phases of the motor
shorted
22
Handle failure Check whether handle is restored to initial state
23 Motor lack of phase
Check if the phase line is good
Check whether the motor phase line is connected
to the controller
24
Motor hall signal cable fault
No hall controller:check whether the phase line is
good with hall controller
：
Check whether hall is in good condition.
25
Braking failure
Before turn on display, check whether Brake is
reset.
30
Controller temperature sensor
failure
Inspect the controller
If an error occurs, try turning your eBike off/On. If the error persists, contact an
authorized service center.
In case of motor overheating, wait for the motor to cool down and after that continue
driving.
General Setup *
Press " +" and " -" buttons at the same time to enter setting item1 at the speed of 0.
Short press " On/Off" button to select the setting item.
Press " +" and " -" buttons at the same time to enter setting item 1 then loose button
，
and then press " +" and " -" to enter setting item 2.
Items to be Set:
•
Display backlight brightness
•
Wheel diameter
•
Speed limit
•
Unit Settings
•
Gear range settings
•
Photosensitive setting
* Some options and features in Setup mode may not be available or may be locked