MRV Communications MRW55, User Manual

Page: 91 / 244

Advanced Configuration
6-33
6
Port Status – Enables or disables the wireless bridge link.
Note:
The wireless MAC address for each bridge unit is printed on the label on the
back of the unit.
CLI Commands for WDS – The following example shows how to configure the MAC
address of the wireless bridge at the opposite end of a point-to-point link, and then
enable forwarding on the link.
Bridge
The wireless bridge can store the MAC addresses for all known devices in the
connected networks. All the addresses are learned by monitoring traffic received by
the wireless bridge and are stored in a dynamic MAC address table. This information
is then used to forward traffic directly between the Ethernet port and the
corresponding wireless interface.
MRW55(config)#wds mac-address 1 00-12-34-56-78-9a 7-43
MRW55(config)#wds enable 7-44
MRW55(config)#exit
MRW55#show wds
7-44
Outdoor_Mode : SLAVE
==================================================
Port ID | Status | Mac-Address
==================================================
01 | ENABLE | 00-12-34-56-78-9A
==================================================
MRW55#