MRV Communications MRW55, User Manual

Page: 182 / 244

Command Line Interface
7-56
7
show filters
This command shows the filter options and protocol entries in the filter table.
Command Mode
Exec
Example
PPPoE Commands
The commands described in this section configure PPPoE management tunnel
connection parameters for the Ethernet port.
MRW55##show filters
Protocol Filter Information
=========================================================
AP Management :ENABLED
Ethernet Type Filter :ENABLED
Enabled Protocol Filters
---------------------------------------------------------
Protocol: ARP ISO: 0x0806
=========================================================
MRW55##
Command Function Mode Page
ip pppoe Enables PPPoE on the Ethernet interface IC-E 7-57
pppoe ip allocation mode Specifies how IP addresses for the PPPoE tunnel are
configured on the interface
IC-E 7-57
pppoe ipcp dns Negotiates DNS for the PPPoE tunnel IC-E 7-58
pppoe lcp echo-interval Sets LCP echo interval for the PPPoE tunnel IC-E 7-58
pppoe lcp echo-failure Sets LCP echo timeout for the PPPoE tunnel IC-E 7-59
pppoe local ip Sets local IP address for the PPPoE tunnel IC-E 7-60
pppoe remote ip Sets remote IP address for the PPPoE tunnel IC-E 7-60
pppoe username Sets the user name for the PPPoE tunnel IC-E 7-61
pppoe password Sets the password for the PPPoE tunnel IC-E 7-61
pppoe service-name Sets the service name for the PPPoE tunnel IC-E 7-62
pppoe restart Restarts the PPPoE connection with updated
parameters
IC-E 7-62
show pppoe Shows information about the PPPoE configuration PE 7-63