SD34002g_e.doc / Sep-13
Page 39 / 60
6.2.6.
Code Protection for Keypad Access
F07
Range
Default
F07.078
Access code for parameter group F01
0
F07.079
Access code for parameter group F02
0
F07.080
Access code for parameter group F03
0 = no protection
0
F07.081
Access code for parameter group F04
0
F07.082
Access code for parameter group F05
1 – 999 999 =
0
F07.083
Access code for parameter group F06
individual
0
F07.084
Access code for parameter group F07
access code for
6078
F07.085
Access code for parameter group F08
the corresponding
6078
F07.086
Access code for parameter group F09
parameter group
0
F07.087
Access code for parameter group F10
0
F07.088
Access code for parameter group F11
6078
F07.089
Access code for parameter group F12
0
F07.090
Access code for parameter group F13
0
In order to avoid inadvertent misadjustment upon commissioning, parameter groups F07
(keypad protection), F08 (special functions) and F11 (Linearization) are already protected by
factory setting. For access please use code 6078
6.2.7.
Special Functions
F08
Range
Default
F08.095
Trigger Threshold 1:
30 … 250
166
Switching threshold for encoder 1 signals *)
F08.096
Trigger Threshold 2:
30 … 250
166
Switching threshold for encoder 2 signals *)
*)
Must be set to the default value (166) at any time, except if exceptionally
single-ended TTL signals should be used. Only in this case a setting of 35 is required.
6.2.8.
Definitions for the Analogue Output (models SA only)
F09
Range
Default
F09.100
Analogue Output Format:
0 … 3
0
0=
Voltage, bipolar -10 V – +10 V
1=
Voltage, unipolar 0 V . +10 V
2=
Current 4 – 20 mA
3=
Current 0 – 20 mA
F09.101
Analogue Start: Beginning of the conversion range (display)
-199 999 … 999 999
0
F09.102
Analogue End: End of the conversion range (display)
-199 999 … 999 999
10 000
F09.103
Analogue Swing:
0 … 1000
100
Full scale voltage or current (100 = 10 V or 20 mA)
F09.104
Analogue Offset: Zero point shift in mV
-10 000 … 10 000
0
F09.105
Analogue Assignment:
0 … 5
(line 1) ... (line 6)
0
Assignment of the analogue output to one of the 6 lines
which can be displayed by cycling
