Motortech MIC-Marine, Operating Manual

Page: 119 / 176

8 Settings via the MICT
Rev. 09/2019 119
– Yellow: The pickup set is being synchronized.
– Gray: No signals are received from the pickup set.
– Control
– Firing Enabled
The green status display signals that the firing is active.
– Schedule A/B
The green status display shows which parameter settings are currently used.
– GPI1
The status display shows the status of the input signal.
– Output
– GPO1, GPO2, GPO3
A green status display indicates that the corresponding general purpose output is
switched on.
– Failure
– Analog Current Input
The red status display signals that the set failure threshold for the input has been
reached. If the lower limit of the signal is reached again, the status display is again
gray.
– Analog Voltage Input
The red status display signals that the set failure threshold for the input has been
reached. If the lower limit of the signal is reached again, the status display is again
gray.
– Ignition Output
The red status display signals a current misfire on at least one output. With a yellow
status display at least one misfire has occurred at one output since the last reset of the
counter.
– Misfire Rate
The misfire rate is displayed for the primary side and secondary side. The misfire rate on the
secondary side is only displayed if the secondary side diagnosis is activated (refer to
section
Engine – Ignition Coils on page 95).
– Single Output
Displays the misfire rate of the output for which the most misfires were registered
during the last 32 cycles.
– All Outputs
Displays the misfire rate for all the ignition outputs for the past 32 cycles.
– The number of misfires per second are calculated by the MIC6 as follows:
2-stroke engine: Number of currently misfiring outputs x RPM / 60
4-stroke engine: Number of currently misfiring outputs x RPM / 60 / 2