Motortech MIC-Marine, Operating Manual

Page: 118 / 176

8 Settings via the MICT
118 Rev. 09/2019
– Global Timing Point
Digital indication of the current global timing
– Operating Hours
– Spark Plugs
Indicates the current operating hours of the spark plugs
– Engine
Indication of current operating hours of the engine
– Device State
The status of the device is shown by the following status displays:
Device status Description
Idle The ignition is ready and waiting for pickup activity.
Synchronizing Pickup signals are being received and analyzed.
Firing Active The ignition is active.
Firing Locked Pickup signals are being received and are valid, ignition is not
released.
Wait for Stop Pickup signals are being received, the ignition fired above the
security speed, and the ignition release was retracted. The
engine must now come to a standstill.
Configuration The device is being configured.
Self Test The self test is running (refer to Self Test on page 78).
Start Phase The engine is in the configured start phase (refer to section
Timing – Schedule A/B – Energy on page 106).
Warning A warning has occurred (refer to Warnings on page 135).
Error An error has occurred (refer to Failure on page 137).
Alarm A configured alarm has occurred (refer to Alarms on page 136).
– Pickup Redundancy
– Enabled
The green status display indicates that in the view Engine – Pickups – General of your
ignition controller’s configuration, the checkbox Enable Redundancy has been activated.
– Available
The green status display indicates that both pickup sets are synchronized and working
error-free.
– Pickup Sets
The status display signals the following states:
– Green: The pickup set works without errors.