Installation Tools and Materials
JAN 2002
1-11
SC
300 1X BTS Hardware Installation, ATP, and FRU Procedures
DRAFT
Introduction
Many of the tools and materials depend on the style of the wall, pole, or
rack that the mounting bracket is being installed on. The tools and
materials required to install the BTS hardware are specified for each
mounting style. Due to the variability of mounting styles, additional
tools and materials may be required to meet specific site needs. This is
outside of the scope of this document and must be evaluated on a site to
site basis.
Also, for each procedure, a tools and materials list is provided within the
procedure.
Motorola kit T393AA is available for most installation styles and
methods. Motorola kit T393AA contains:
Torque driver wrench, 1/4–in. hex female drive, 0–10 N–m
T20 Torx Tamper Bit, 1/4–in. hex
T30 Torx Tamper Bit, 1/4–in. hex
Flathead bit
Torque ratchet wrench 3/8–in. drive, 0–10 N–M (Utica part number
TCI–150 R/A 3/8–in. or equivalent)
5/16 Breakaway 9–in. lb.
13/16 Breakaway 38–in. lb.
Wire Crimping Tool
Installation Handles, Motorola Part Numbers (Left Handle
0787668C01) and (Right Handle 0787668C02)
Screws M6x19 (Motorola Part Number 0387541C03)
Buckle Strap Tool
Required Tools and Materials
for Installing the Mounting
Bracket on a Pole
The following tools and materials in Table 1-1 are required to properly
and safely install the the mounting bracket on a pole.
Table 1-1: Required Tools and Materials for Pole Mounting
Hand Tools
Materials
Power Tools
Safety Glasses
MicroCell mounting kit
No Power Tools Required
Bucklestrap Cutting Tool (Motorola
part number 6604809N01)
electrical tape
(customer supplied)
T30 TORX tamper bit, 1/4–in. hex
Torque driver wrench, 1/4–in. hex
female drive, 0–10 N–M
Ball Peen (Metal Working) Hammer
Heavy Gloves
Tape Measure
1
