Motorola SB1, Integrator Manual

Page: 17 / 136

Initial Setup 1 - 3
Figure 1-3
Calibration Screen
Leave the SB1 in the cradle until it is fully charged. The LED indicates the SB1 battery charging status. The
battery fully charges in approximately four hours. See
Table 1-1 on page 1-3
for charging status indications.
When the LED lights green remove the SB1 from the cradle.
Carefully press and briefly hold finger tip on the center of the
Calibration
screen target. Repeat the procedure
as the target moves and stops at different locations on the screen. After the calibration settings are input, tap
the screen to save the new calibration settings.
When using the SB1, if the battery charge falls below a predetermine level, it shuts down and displays the
Battery Discharged screen.
Figure 1-4
Battery Discharged Screen
When this occurs, immediately recharge the SB1 battery by placing it into a charging cradle. The Battery
Charging screen appears on the display indicating that the battery is charging.
Table 1-1
LED Indicator
LED Indication
Off SB1 not placed correctly in the cradle.
The cradle is not powered.
SB1 is not functioning properly.
Slow Blinking Amber SB1 is charging.
Solid Green Charging is complete.
Fast Blinking Amber Charging error.