Motorola SB1, Integrator Manual

Page: 16 / 136

1 - 2 SB1 Integrator Guide
Charging the SB1
When the SB1 is off it displays the Regulatory Label information screen.
Figure 1-1
Out of the Box Screen
Use the Single Slot Charging cradle or Ten Slot Charge Only cradle to charge the SB1. To charge the SB1,
slide it into the cradle slot with the Scan button facing up.
Figure 1-2
Single Slot Charging Cradle
When the SB1 powers up a beep sounds and the Calibration screen displays.
CAUTION
Follow the guidelines for battery safety described in
Battery Safety Guidelines on page 5-1
.
The SB1 must be charged within the 0 °C to +40 °C (32 °F to 104 °F) ambient temperature range.
LED Scan Button
NOTE
If the battery is at a very low level due to the SB1 being left out overnight or stored for long periods, the
SB1 might not power up immediately but the LED blinks. When the SB1 is placed in the charging cradle, it
might not fully power up right away. After a few minutes, the SB1 boots normally.