Installation
40
68P81096E37-N
06/28/05
Location of Telephone Line Connections
Wireline Connector
When 4-wire (2 line) telephone connections are required, Line 1 and Line 2
are provided through the 4–position wire wrap terminal connector.
Table 10 provides a description of the Wireline connector line pair assign-
ments.
Connector 4 has 8 holes:
-
the round holes are for wire insertion, and
-
the square holes are for insert release.
This wire-trap terminal connector accepts only 0.52 sq mm (20 AWG) to
0.2 sq mm (24 AWG); solid wire or stranded wire with a tin topcoat. Wires
inserted into the connector should be stripped to length 9.53mm (0.375 in).
As a removal release tool, use either:
-
a stripped wire of any of above sizes, or
-
the Wireline connector tool, part number 6600809D00.
Before applying excessive pullout force on the telephone connection
wires, be sure to release wires properly.
System Connector
When 8-wire (4 line) telephone connections are required:
-
Line 1 and Line 2 are provided through the 4-terminal Telephone con-
nector.
-
Line 3 and Line 4 are provided through the System connector.
The location of the Telephone and System connectors on the station rear
panel is shown in Figure 9.
Table 4 describes the System connector pin assignments for Line Pairs 3
and 4.
Table 10. Wireline Connector Line Pair Assignments
Line Pair
Functionality
1 +/–
Tx wireline input for 4 wire configuration.
Input level is programmable by RSS between 0 dBm to
–50 dBm.
Do not use this line pair for 2 wire wireline
configuration.
2 +/–
Rx wireline output for 4 wire configuration.
Output level is programmable b7 dBm to
–20 dBm for 100% deviation.
Use this line pair for 2 wire wireline configuration.
CAUTION
!
