Installation
16
68P81096E37-N
06/28/05
Cement dust from concrete flooring is harmful to electronic equipment
and wiring. Make sure that the rack and any collocated equipment are
protected prior to drilling holes in the concrete floor. Use a tarpaulin,
cloth, or plastic sheeting to cover exposed equipment. (The rack should
be already covered with an antistatic bag; do not remove the bag at this
time.) Use a vacuum while drilling the holes to minimize the spread of
concrete dust. Carefully clean up any accumulated dust and debris from
the anchor installation before uncovering the equipment.
Mounting Floor-mount Cabinets
Each cabinet bottom is pre-drilled with four (4) mounting holes to allow
attachment to the site floor. If installing on a concrete floor, use the cabinet
as a template, mark the hole locations, and follow the procedures above for
anchoring equipment racks. If installing on a wooden floor, use lag bolts
and washers (customer supplied) to secure the cabinet to the floor.
Transferring Equipment from Shipping Container to Rack
or Cabinet
As mentioned under Equipment Unpacking and Inspection, a station can
be shipped in a box. Upon delivery, the equipment must be removed from
the container and transferred to a Motorola-supplied rack or cabinet, or to
a customer-supplied rack or cabinet.
Customer-supplied cabinets and racks must have mounting rails and hole
spacing compatible with EIA Universal 48.3cm (19in) specifications. Cab-
inets must provide adequate ventilation (as detailed under Equipment
Ventilation) and must meet the following criteria:
-
41.3cm (16.25in) deep
-
48.3cm (19in) wide
-
13.4cm (5.25in) high
-
Two mounting rails 5cm (2in) from front of cabinet with front mount-
ing holes 5.7 cm (2.25in) apart (center to center).
Contact Motorola Engineering for specific questions regarding mounting
equipment in customer-supplied cabinets.
CAUTION
!
Note
