Motorhispania MH7 Naked, Workshop Manual

Page: 62 / 138

70
5 ELECTRICAL SYSTEM
8. SET-UP MENU
The entry in the set-up menu is only possible when the
vehicle is stopped by pushing at the same time the
Mode and the Set button for about 04 seconds
regardless the visualized function.
On the display the “SET Par” logo will appear fi xed (as
in the picture 8-1) for the entry in the set-up menu of
parameters.
Obs.8-1: If the input #5 (settings) on the connector
is connected to ground, it is possible to change every
parameter.
If the input #5 (settings) on the connector is not con-
nected to ground (default condition), it is only possi-
ble to change measurement unit.
8.1. Parameters SET-UP menu
This menu allows to modify the following parameters:
To save the modifi cations in the memory, it is necessary
that the set-up procedure is completed using the Mode
button by keeping pressed the Mode button in corres-
pondence of the measurement unit selected.
When the dashboard is in the set-up menu, if :
• Velocity becames >0
• The button is not pushed for 20 seconds.
The dashboard will exit from setup menu without saving
any changes and will restore the previous
values.
Only in the case in which the procedure of Set-Up is
completed in a correct way, the system goes
on with the saving in permanent memory of all the
made selections.
(factory)
(factory)
(factory)
(f user)
Picture 8-1: parameters set-up
menu
• Wheel circumference (min 1.000mm max 2.500mm)
• Number of pulses for every turn of the wheel (min 1 max 12)
• Number of pulses for every turn of the engine (min 1 max 8)
• Measurement unit of distance (km/h or mph)